Home

Electrode Placement Chart

Electrode Placement Chart

Use this chart as a reference to guide you in placing your tens unit or ems unit electrodes. If you consult with a medical professional about using your tens unit, they will likely be able to assist you further in determining where to place your tens unit electrodes.

Additional Electrode Information

  1. Electrode Skin Care
  2. Application of Re-usable self Adhesive Electrodes
Electrode Placement Chart


Use this chart as a reference to guide you in placing your tens unit or ems unit electrodes. If you consult with a medical professional about using your tens unit, they will likely be able to assist you further in determining where to place your tens unit electrodes.

It is also highly recommended you read our documentation for those who should not use a TENS and EMS unit.

Electrode Skin Care

  1. Wash the area of skin where you will be placing the electrodes, using mild soap and water before applying electrodes, and after taking them off. Be sure to rinse soap off thoroughly and dry skin well.
  2. Excess hair may be clipped with scissors; do not shave stimulation area.
  3. Wipe the area with the skin preparation your clinician has recommended. Let this dry. Apply electrodes as directed.
  4. Many skin problems arise from the “pulling stress” from adhesive patches that are excessively stretched across the skin during application. To prevent this, apply electrodes from center outward; avoid stretching over the skin.
  5. To minimize “pulling stress”, tape extra lengths of lead wires to the skin in a loop to prevent tugging on electrodes.
  6. When removing electrodes, always remove by pulling in the direction of hair growth.
  7. It may be helpful to rub skin lotion on electrode placement area when not wearing electrodes.
  8. Never apply electrodes over irritated or broken skin.

Application of Re-usable self Adhesive Electrodes


Application

  1. Clean and dry the skin at the prescribed area thoroughly with soap and water prior to application of electrodes.
  2. Insert the lead wire into the pin connector in the pre-wired electrodes.
  3. Remove the electrodes from the protective liner and apply the electrodes firmly to the treatment site.
Removal

  1. Lift at the edge of electrodes and peel; do not pull on the lead wires be cause it may damage the electrodes.
  2. Place the electrodes on the liner and remove the lead wire by twisting and pulling at the same time.
Care and Storage

  1. Between uses, store the electrodes in the resealed bag in a cool dry place.
  2. It may be helpful to improve repeated application by spreading a few drops of cold water over the adhesive and turn the surface up to air dry. Over Saturation with water will reduce the adhesive properties.
Very Important!

  1. Do not apply to broken skin.
  2. The electrodes should be discarded when they are no longer adhering.
  3. The electrodes are intended for single patient use only.
  4. If irritation occurs, discontinue use and consult your physician.
  5. Read the instruction for use of self-adhesive electrodes before application.